Vicor VIPAC Array CONFIGURATION GUIDE Manual do Utilizador descarregar pdf (Página 5)

vicorpower.com/vcad

Pin# Funct.

1-4 –Vin

5-7 +Vin

8 NC /PR bus

9 PE protective earth

10 Neg. enable

11-13 –Vin

14-17 +Vin

18 NC /PR bus

19 PE protective earth

20 Pos. enable

VA-J and VA-K configurations only

(300 and 375 Vin single Maxi or single Mini)

Pin# Funct.

1-3 –Vin

4-6 +Vin

7NC

8 NC /PR bus

9 PE protective earth

10 Neg. enable

11-13 –Vin

14-16 +Vin

17 NC

18 NC /PR bus

19 PE protective earth

20 Pos. enable

Input / Output Connections

Mating Connector

Vicor part # Amp part#

Housing 24795 2-794657-0

Contacts 24796 1-106529-2

Kit 24828

Input Connector

(View looking into J1)

Solder

Pin # Pad Function

1 – Vout

Rd Trim Down

SC Secondary Control

Ru Trim Up

3 + Vout

Consult design calculator for Rd/Ru trim resis-

tor values located at vicorpower.com

Factory installed Micro LugMate

*Removable

Jumper

*Removable

Jumper

Discrete Output

Factory installed Mini/Maxi LugMate

3131

Shown with the output(s) of two modules

connected in parallel using factory installed

bus bar.**

To disable output(s) apply +5 Vdc between pins

10 and 20 in the polarity indicated

P/N 16385

–S

Parallel Output

Pin # Conn. Function Mating Conn.

1 – Vout

J4-1 – Vout

J4-2 – Sense

J4-3 Secondary Control P/N

16385

J4-4 + Sense

J4-5 + Vout

5 + Vout

*Removable jumpers in J4 are factory installed for local

sensing. For remote sensing the +Sense pins should be

tied to the same point on the +Out power bus;

the -Sense pins should be tied to the same point the -

Out power bus.

1 2 3 4 5 6 7 8 9 10 ... 13 14

Comentários a estes Manuais

Sem comentários

Vicor VIPAC Array CONFIGURATION GUIDE Manual do Utilizador Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Vicor VIPAC Array CONFIGURATION GUIDE